Use method of thermostatic water bath

1. If warm water is added during use, heating time can be shortened and power consumption can be saved.

2. Turn on the power switch, and the power indicator lights up to indicate that the power is correctly connected.

3. Set the equipment to the required temperature, and the heating indicator light is on, indicating that the power supply of the electric heating tube is connected for heating. When the temperature on the thermometer reaches the required temperature, wait for a few minutes before starting automatic thermostatic control.

4. The scale of thermostatic controller is only used for temperature comparison indication, not for temperature indication scale.

Precautions for thermostatic water bath

1. The box shell must be effectively grounded.

2. Do not turn on the power supply before adding water to prevent the hot wire of the electric heating pipe from burning.

3. Do not disassemble the right differential plate for safety unless necessary.

Maintenance and repair of thermostatic water bath:

1. Turn off the power supply after use.

2. The inside and outside of the box should always be kept clean.

3. If the warning light is not on, turn off the power supply first, pull out the plug and remove the right plug board. If the fuse or indicator bulb is damaged, it can be replaced with the same specification.

4. If the thermostatic control fails, the sensor on the controller fails. It can be used after replacement.