Clean the sink and water ring

At the beginning, disconnect the power supply of the water ring vacuum pump and drain the water from the water tank. Then, disassemble the water ring section and clean it thoroughly. You can use mild cleaning agents and soft brushes or sponges to clean the sink and water ring. Be careful not to use corrosive cleaning agents to avoid damaging the surface of the parts. After flushing and cleaning, ensure that the sink and water ring are completely dry.

Clean water pipes and filters

Check the water pipes and filters for blockages or accumulated dirt. If there is dirt, you can use a soft brush or water gun to clean the water pipes and filters. Ensure that the water pipes and filters are completely dry before reinstalling.

Check and replace seals

Regularly inspect the sealing components of the water ring vacuum pump, such as O-rings and gaskets. If aging or damage is found to the sealing element, replace it with a new one in a timely manner to ensure good sealing performance.

Clean the air inlet and outlet

Check and clean the air inlet and outlet of the water ring vacuum pump. These mouths often accumulate dust, impurities, and oil stains. Use a soft brush or compressed air to clean the inlet and outlet ports and ensure that they are unobstructed.

Regular maintenance and upkeep

Establish a regular maintenance and upkeep plan, regularly inspect and clean the water ring vacuum pump. According to the manufacturer's recommendations, lubricate and replace parts to maintain the normal operation of the pump.

Please note that when cleaning the water ring vacuum pump, caution should be exercised and relevant AN regulations should be followed. If unsure about the cleaning process, it is recommended to consult the manufacturer or professional technical personnel for advice. Proper cleaning and maintenance will help maintain stable performance and extend the service life of the water ring vacuum pump.